ISEO R700 Cylinder prepared for knob installation series: interface, basic dimensions and configuration conditions

Cylinder dimensions

Measure both sides from the fixing screw. Check the cylinder profile, cam and version.

Specifications

Information scope

Construction series; wildcard code is not a complete order code

Construction

Cylinder prepared for knob installation

Catalogue basic dimensions C/D

30/30 mm

Coding construction

Up to 14 coding-pin positions

Cam

30° DIN cam

Driver-pin material

Stainless steel

Anti-drill devices

Anti-drill devices at both ends of the cylinder housing and rotor (manufacturer's description)

Construction Version

Compact and modular; select when ordering

Prepared shaft projection

16 mm ( Catalogue drawing)

A prepared interface is not an installed knob

This construction has a prepared knob mounting shaft, with the projecting section marked 16 mm in the drawing. Confirm the matching knob, fixing method and shaft interface when ordering; it differs from a version with a factory-installed round knob.

R700 coding and mechanical construction

This R700 page describes up to 14 coding pins and a reversible key. Reversible refers only to insertion direction; it does not replace verification of key coding and the authorisation system.

This page also explicitly specifies stainless-steel driver pins, a 30° DIN cam and anti-drill devices at both ends of the cylinder housing and rotor (manufacturer's description). Check the key system, cam and mechanical interface separately when selecting replacements.

Basic configuration and complete order code

The catalogue Basic configuration line states 30+30, with wildcard code 8*R76*******H*26. This identifies the construction's basic dimensions and code range; asterisks indicate options requiring further selection.

C and D are measured from the fixing screw centre to each end. Even when the basic configuration has equal sides, record cylinder protectors, trim plates and operating clearance on both sides of the door.

When requesting a quotation, provide the series, operating construction, required C/D, interface and key-system requirements together. Have the manufacturer confirm the complete code and final installation drawing.

Limitations

• Complete catalogue-code asterisks and placeholders according to actual dimensions, construction and finish. The code cannot be used directly as an orderable SKU.
• Basic dimensions are only the starting configuration explicitly listed on this page. Check other sizes against the manufacturer's complete configuration rules; not all C/D combinations are necessarily available.
• Catalogue construction information does not guarantee current stock, local supply or compatibility with an existing door lock.

Sources

Manufacturer documents are provided in their original language.

Related articles